SCC at the Three Peaks Cyclo-Cross Race 30th Sept 2018

Chris Rose writes


Four representatives of Skipton Cycling Club took part in the challenge of the Three peaks Cyclo Cross on Sunday: Rick S, Sean McK, Steve H and Adam W.
It was a chilly day with grey cloud but no rain. There was a bit of a discussion at the start about how much kit to wear followed by a warm up ride up Stackhouse Lane.
Paul N and Chris R (support Team) took possession of a variety of gels, bananas and drinks with  a list of projected timings at the two key “dibber” points: Cold Coats and Ribblehead.
We left the riders for the race briefing and headed off to Cold Coats, via the Community shop for a breakfast snack.
From 10.30 am onward the leaders came through at great speed, some interesting bike swaps, speedy repairs and fuel handovers occurred. Sean was through first, quickly followed by Adam then Steve and Rick (bang on 11.08 am as predicted).
We then joined the convoy of cars heading up to Ribblehead (with a quick stop over in Ingleton for – a not great – coffee!)
Sean was so speedy we missed him at the dibber point but were able to cheer Adam along and hand over the drinks and gels to Steve and Rick (again, bang on time 12.47)
The final check for us was Pen Y Gent Lane. Paul was stationed strategically with spare wheels and final emergency rations.
I continued to the finish to see the riders complete the course.
Sean had a noticeable tuft of grass attached to the top of his helmet! He had fallen off, landing head first.
That slight delay plus the need to mend a snapped chain, did not prevent him from coming in first for the SCC team . Splendid!
Adam completed next, his rear mech still intact – well done!
Steve was ahead of the MV60/Rick for the majority of the race until, on finding  a final burst of energy, Rick finished 2 minutes ahead of him.
A most creditable showing for the club. All finishing in under five hours!
It is the most amazing event, a real challenge, to say the least, and certainly a ‘high end’ competition.

Leave a Reply